Hello Everybody I buy a datalogic scanner/scale 9500xt recently and m trying to configure it with samba. the problem is when m scanning any barcode scanner giving me a label id with barcode i.e S08xxxxxxxx16. Now my question is does anybody experience the same problem? or does anybody have a experi…

Surely you have some setup barcodes to work through to setup the scanner correctly. When I got my metrologic voyager scanner I had to scan setup barcodes for it to recognise different types of barcodes and had to scan a barcode setting to add a carriage return at the end of the barcode (this simulat…

[image] Faisal: Yes right and I already have one similar setup but the problem is I have to press enter after each scanning. SO LISTEN TO ME FFS [image] JTRTech: So either way you want to config scanner. Even without the prefix this will still be the case as typically the scanner suffix…

@Faisal please ask datalogic how to append weight information to the scanned barcode. It should return a barcode that configured like. S08 123456789012 01200 ^Prefix^ ^Barcode ^ ^Weight^` So SambaPOS can parse the weight from barcode. This is an industry standard.

I think @JTRTech you getting me wrong. I understand your point but m not sure if you talking about number pad action and rule similar like this: [image] [image] this rule read the PLU and break item code and price but after breaking it come to number pad and I have to enter it.

Because your scanner hasn’t got the carriage return setting added!!

You need to find the configuration barcode that adds a carriage return when you scan Carriage return “presses” enter for you, you haven’t configured your scanner to do this so you have to manually press enter

@Faisal you dont half make this hard. That setup was on different topic, you act like a reseller but we shoudl presume this is linked to your other question. You say prefix is problem, then its that you need to press enter. If it is entering and this rule is parsing the barcode then we are back to…

Wait guys I think there is some misunderstanding. Forget scale and weight barcode. from this device right now m trying to scan some items. I configured the serial port already with DL Wedge Utility and scanner strated to scan. But the problem is its giving me a prefix in the beginning and samba not …

Or change the rule above to have an alternate flow for numberpad starts with s08!

[image] RickH: Because your scanner hasn’t got the carriage return setting added!! It is probably not entering to allow software to connect to scale and read weight.

SambaClub Forum

Datalogic Scanner/scale configuration

V5 Question

show post in topic

Home
Categories
Guidelines
Terms of Service
Privacy Policy

Powered by Discourse, best viewed with JavaScript enabled